And if you happen to need something similar, some of the negative carriers cam be had pretty cheap. So now I'll use those negative carriers for digitizing and for enlarging. That enlarger has a bunch of negative holders (at the moment, 4x5, 6x7, 6圆, 6x4.5, 35mm, and one with a small square opening, I'm guessing for 126 film, but I don't know.) It turns out that these are perfect for holding the negatives flat (go figure), and the thickness of the bottom plate is sufficient that I don't see any grid when shooting at ƒ8. Check out these other light box ideas, too For ours, I used a translucent under-the-bed storage bin. Drill holes at the bottom of the box to fit rope lights, then place rope lights on top of the lid. Then spray paint the inside of the box with metallic spray paint and the lid with frosted spray paint. Ask Question Step 2: Place the Lights Into the Box Open the clear plastic box and place all 4 lights into the box. Follow the pictures inside the compartment if you need assistance with this step. Then I realized-I have an enlarger that I'm trying to get setup to do wet prints. There are lots of ways to make your own DIY light table, and about a zillion things to do with it. To make your light table, use a table with a flat surface for the base of the box. Step 1: Add the Juice Open the battery compartments and place 4 AA batteries into each light. I seriously considered buying a used Pentax 67 bellows with its 6x7 slide copier, and a 67 to K mount adapter, but that setup is VERY expensive. 35mm was solved because I have a Pentax bellows with slide copier, but my medium format was suffering. I was trying to hack a method to hold the film flat and away from the iPad, and was banging my head against the issue.
0 Comments
Leave a Reply. |